Hi,

Yes it works, calibration is also possible. I will use it to measure the ground water level, with a bubbler. It will take time for making the right arduino sketch to send the measurement to Domoticz. I just beginning with it and I am almost 70. I will use the Nano and NRF24L01 and the Sensbender gateway for it.

Thanks for suggestions I try to get things working.

HI,
Recently i buy a pressure sensor on a board with a HX710B chip, Has any one info about this sensor. the Chinese seller could not help me further.
There are 4 connextions VCC and GND and out and SCK.
Regards Rien.