there is one more advantage for us users when it's done in china. It will save the process of copying the design to produce it in higher volumes for small money. When the chinese realize, the boards will be sold it should go quite fast ;)

Will the pcbs be assembled with the parts? at least the smd stuff?
I wonder why there is now NRF-pcb availeble which can be pluged direct onto an arduino. the chines sell so many little different pcbs, but nothing with NRF and atmegaxxx togehter on one board. the only one i found is an ATMega48 with connector for the NRF. But the mega48 is a little low on flash.

Also, what do you think of the MicroMesh-PCB? (if availeble one day.....) ?

Well, I'm on a diet right now, so no need for candy. But is there an estimated time for the mySensor PCB?

will try them, thanks.

O.K.
No I don't have designer skills. I only need to look the sensors acceptable, so they are not removed "by accident" by my wife ;)
And I was thinking of a case, where the Batterys (A or AA) can b e connected without soldering. There must be a chinashop where to by little plastic cases with Battery holder, at least I hope so.
Ralf

Hello,
any suggestions out here wich Hardware to use for:

little Sensor, with 2 ReedContacts and 18b20?
which case? (incl. Battery holder)?
which Arduino?

Which hardware do you use for Sensor like this?

Thanks,
Ralf