Wired up a w5100 and radio as shows in the ethernet gateway build page. Using a generic arduino uno with the w5100 hooked up to 5v and the radio hooked up to 3.3.
Serial Monitor shows:
0;255;3;0;9;Starting gateway (RNNGA-, 2.0.0)
0;255;3;0;9;TSM:INIT
0;255;3;0;9;TSM:RADIO:OK
0;255;3;0;9;TSM:GW MODE
0;255;3;0;9;TSM:READY
IP: 10.0.0.25
I cannot see the IP address on my router device page.
Vera says: MySensors plugin : Cannot send command - communications error
Any ideas?
I have several temp sensors and relays I would like to automate and put on one arduino. I understand how to wire and power up everything, but the programming part eludes me. How do I put together the various bits of codes provided onto the arduino? I understand how to upload code and such but putting the code together is confusing. Please help!
Yup, going over the ethernet gateway then. Thanks for the replies!
Just figured it out, it has no FTDI chip. Where can I get a nano with a real FTDI chip?
Or can I just go with an ethernet gateway with my existing nano? I have the ethernet part.
I have tried accessing that menu but it only says:
Serial Port configuration
If you connected the USB/serial device and it's not displayed here, reload Luup.
Save
Not available
So options are available there..
New to Mysensors, amazing stuff, having a blast.
Just a little problem I can't seem to fix:
Put together my serial gateway with NRF24L01 radio and a Nano, checked debug to make sure it was working correctly, all seems well. Started up Vera, uploaded LUA files, created device, plugged in Serial Gateway to USB on Vera, restarted LUA engine, restarted the Vera, and nothing. I get a 'lua startup failure' error on the devices section in Vera on the MySensors Plugin.
What gives?