I'm kind of a newbie too, but yes I think you need a controller. It's the controller who assigns ID's to the sensor nodes.
Striffster
@Striffster
0
Reputation
6
Posts
507
Profile views
0
Followers
4
Following
Best posts made by Striffster
This user hasn't posted anything yet.
Latest posts made by Striffster
-
RE: Newbie Problem! Get Started with NRF24L01+
-
RE: Newbie Problem! Get Started with NRF24L01+
Have you set up any controller? For example Domoticz or MYSController?
-
RE: Domoticz wont toggle light switch via ethernet gateway?
@floris Ok thanks, I've seen that post but that was not a solution to the oneway communication.
-
RE: Domoticz wont toggle light switch via ethernet gateway?
@floris Do you have any link, I have searched the Domoticz forum without success.
-
RE: Ethernet gateway doesn't work with Domoticz.
@kunall Please post a note here if you will get any solution from Domoticz.
-
RE: Domoticz wont toggle light switch via ethernet gateway?
I have the same issue, if I use Myscontroller it works using the ethernet gateway but not when using Domoticz.