How control W5500/W5100 (with STM32) by mysensors library
-
I have a problem with W5500/W5100/ENC28j60 and STM32. Each of these ETH modules jams after a few days. STM32 works correctly but has no knowledge of the lack of network connectivity. Is there any way to detect this condition and reinitialize the W5500/W5100 module? To be clear - the modules do not respond to PING.
-
I found procedure gatewayTransportInit(), it works great. However, I cannot find a procedure that will enable detection of a network connection at level mysensors. I noticed that disconnecting the network plug or resetting the W5500 (37 pin to ground) changes the device's IP address to 0.0.0.0 - then I call gatewayTransportInit() - but mysensor's library must have such procedures - please tell me how to diagnose ethernet connection.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login