Sensebender with RFM69
-
Got my converter boards for RFM69 -> NRF24 footprint in from Dirty pcb's today, and it seems that the sensebender has accepted it's new friend..
However, the GW that I have set up, doesn't receive anything (they are within 5cm of each other). So I have to do some good old hardware debugging (on both sides)..
-
Would you care to share schematics?
-
The design is available on openhardware https://www.openhardware.io/view/16/NRF2RFM69
-
Well i don't know wich RFM69 you use but i have here a few moteino's and also toy-ing with them i had similar problem no data exchange possible between the two moteino's. whatever i try no connection was builtup. i even unsolder a rfm69HW on the GW and replaced it.. it communicates??? So conclusion bad RFM69 Throw away.. and test further. After a few days again same problem. Now it was on the breadboard so replacing was easy. Same as before (replace and works).
Then i loaded up the moteino test program in the sensornode and the GW with the non working RFM69 .... Works like a charm??? switch back to Mysensors works again.. I Can't remeber anymore what i did but you have to look at the code n the utility folder the rfm69.cpp file in the initializer. when there is no encryption (NULL) the encryption string is not written.. so ones it's filled in you can't clear it. I suspect that the problem relies there..
regards, Stefan.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login