Connecting FTDI header to nano to read serial monitor?
-
Hey,
is it possible to connect the FTDI header normally used to programm the pro mini to my nano to read the serial monitor? I didn't thought about positioning the nano properly before soldering and the usb port is not accessible while running. Therefore I thought about connecting GND, RX and TX to my FTDI and read serial. Will this work or will it fry the nano or FTDI?
-
It will work.
-
well... I tried, but didn't see anything on serial. Just having GND<--> GND, TX<-->RX and RX<-->TX. Anything further to connect?
-
Did you check RX and TX channels? My serial to usb converter has the labels already switched (so I have to connect Rx to Rx and Tx to Tx).
1 out of 4
Suggested Topics
-
Over the air updates
General Discussion • 23 Mar 2014, 21:38 • ToSa 1 Mar 2015, 11:21 -
Best time of year to buy higher quality small project solar panels?
Hardware • 10 Jun 2021, 19:19 • NeverDie 30 Aug 2024, 14:01 -
Arduino Nano Every problem
Hardware • 1 Feb 2020, 09:18 • hakha4 5 Dec 2023, 02:21 -
hlk-pm01 are to noisy for rfm69?
Hardware • 5 Aug 2023, 21:16 • Tmaster 9 Aug 2023, 16:28 -
Sleep mode for bmp280
Hardware • 20 Feb 2018, 13:24 • fishermans 5 Feb 2024, 18:30 -
Sensor to detect marijuana vape/smoke
Hardware • 21 Jan 2025, 06:36 • Hellmark 25 Feb 2025, 20:56
