Connecting FTDI header to nano to read serial monitor?
-
Hey,
is it possible to connect the FTDI header normally used to programm the pro mini to my nano to read the serial monitor? I didn't thought about positioning the nano properly before soldering and the usb port is not accessible while running. Therefore I thought about connecting GND, RX and TX to my FTDI and read serial. Will this work or will it fry the nano or FTDI?
-
It will work.
-
well... I tried, but didn't see anything on serial. Just having GND<--> GND, TX<-->RX and RX<-->TX. Anything further to connect?
-
Did you check RX and TX channels? My serial to usb converter has the labels already switched (so I have to connect Rx to Rx and Tx to Tx).
4 out of 4
Suggested Topics
-
Over the air updates
General Discussion • 23 Mar 2014, 21:38 • ToSa 1 Mar 2015, 11:21 -
Best VOC sensor for detecting a wide range of VOC's?
Hardware • 26 Oct 2023, 23:59 • NeverDie 18 Nov 2023, 01:41 -
Sleep mode for bmp280
Hardware • 20 Feb 2018, 13:24 • fishermans 5 Feb 2024, 18:30 -
Does MySensors require Arduino Timer 2?
Hardware • 6 Jan 2024, 19:39 • OldSurferDude 11 Jan 2024, 04:39 -
hlk-pm01 are to noisy for rfm69?
Hardware • 5 Aug 2023, 21:16 • Tmaster 9 Aug 2023, 16:28 -
Newbie questions
Hardware • 14 Feb 2025, 20:03 • magwas 14 Feb 2025, 20:03
