ITEAD RBoard (4 relay)

[timg]

Hi Everyone!

I saw a couple of posts on the site in relation to boards from ITEAD STUDIO. I purchased the single relay unit and the 4 relay unit.

I was able to easily get the single relay unit working through Vera (like @gregl) Although I still get some sync issues with Vera, like I have with relay units built on Uno'S. Not so much luck with the 4 relay unit, I'm getting the check wire error in the serial monitor (have tried other radios). I wonder if my problem is with the mapping of the radio?

http://imall.iteadstudio.com/im120618001.html
ftp://imall.iteadstudio.com/IM120618001_RBoard/DS_IM120618001_RBoard.pdf

Here is the pinout of the 4 relay unit:

Pin of Arduino Description
D0 = RxD
D1 = TxD
D2 = XBee Reset
D3 = nRF24L01+_IRQ
D4 = R0
D5 = R1
D6 = R2
D7 = R3
D8 = nRF24L01+_CE
D9 = nRF24L01+_CS
D10 = SD_CS
D11 = SPI_MOSI
D12 = SPI_MISO
D13 = SPI_SCK
A0 = AD0
A1 = AD1
A2 = AD2
A3 = AD3
A4 = AD4/IIC_SCL
A5 = AD5/IIC_SDA

Any suggestions? If it is related to radio pin mapping what would I need to edit?

Thanks,
Tim

[timg]

I cross referenced the (working) single relay board with the radio mapping on the Uno's and they are the same.

So my problem is mapping of the radio on the 4 relay unit. Could someone advise what I need to edit in the sketch or config file to map the pins that are required by the 4 relay unit (as detailed above)?

Thanks in advance,
Tim

[timg]

Just reading this post from @gregl. Iboard - Cheap Single board Ethernet Arduino with Radio. This may be helpful !

[gregl]

Hi Timg - There is a copy of my heater sketch using the 4relay Rboard. Here:
http://forum.mysensors.org/topic/282/heater-device/3

It contains a note about the CE/CS pins ( plugin 1.3)

//Sensor gw;
Sensor gw(8,9); //Rboard PCB uses different pins for CE/CS - also interupt, but this isnt used at this time.

This is a fantastic board which has been working for the past few months with zero issues! I still havent properly boxed it up. I'll await the warmer months to do this.