Type mistake
-
Hello,
It is no bug but a type mistake
select the correct Port from the Tools menu then open the Serial Monitor to view the debug messages. Note: the default Baud Rate for MySensors is 112500
This to your informationGreatz Ton
-
Thanks for reporting this @TON-RIJNAARD, much appreciated.
Where did you find the mistake? Was it in a Sketch? If so, which sketch? Was it on a page? If so which page?
-
Hello,
It is on this page
https://www.mysensors.org/build/debugBuild and upload the sketch with the above debug flag enabled in MyConfig.h.
Keep the sensor connected to your computer and enable the Serial Monitor in the Arduino IDE. Tools>Serial Monitor.
Set the baud-rate to 115200.
-
@TON-RIJNAARD Thanks! I have fixed the page, it now says 115200.
1 out of 4
Suggested Topics
-
Code for beta-testing?
Controllers • 24 Mar 2014, 20:48 • andriej 9 Aug 2014, 10:44 -
sleep(0) in V2.1 doesn't sleep indefinitely anymore. Used to powerdown and sleep in V1.5
Bug Reports • 22 Nov 2019, 00:35 • GaryStofer 15 Apr 2023, 05:50 -
NRF51-52 PA not support ???
Bug Reports • 23 Feb 2019, 16:40 • berkseo 8 Jul 2021, 11:42 -
RFM95W sleep() directly after send() often doesn't sleep radio
Bug Reports • 1 Jan 2023, 18:41 • prawnpie 8 Jan 2023, 05:36 -
ACK -aka ECHO beeing missed by Serial Gateway with RF24 radios. V2.3.2
Bug Reports • 15 Apr 2023, 06:27 • GaryStofer 21 Apr 2023, 17:34 -
ESP32 + Signing fails after xxx msg as result of memory leak
Bug Reports • 6 Apr 2020, 18:43 • Technovation 7 Mar 2022, 10:37
