Status LED issues with Raspberry Pi gateway
-
Morning all.
Ive just had to completely rebuild my openhab and mysensors set up. Im running OH 2.4 on a Raspberry Pi 3B+, with the MySensors 2.4 bindings. Gateway compiles and runs fine....butttt I acidentaly configured --my-leds-blinking-inverse. How do i unconfigure it.Second led issue. The red error led is always lit, no blink, just steady burn. It is wired as noted in the guide.
Should i reneter the options and then remake the gate way? Im not sure how to go about this I was using arduinos before and there you just deleted the options from the sketch and reloaded it.
Thanks for the advice in advance
-
Morning all.
Ive just had to completely rebuild my openhab and mysensors set up. Im running OH 2.4 on a Raspberry Pi 3B+, with the MySensors 2.4 bindings. Gateway compiles and runs fine....butttt I acidentaly configured --my-leds-blinking-inverse. How do i unconfigure it.Second led issue. The red error led is always lit, no blink, just steady burn. It is wired as noted in the guide.
Should i reneter the options and then remake the gate way? Im not sure how to go about this I was using arduinos before and there you just deleted the options from the sketch and reloaded it.
Thanks for the advice in advance
@dbagioni said in Status LED issues with Raspberry Pi gateway:
How do i unconfigure it.
According to: https://github.com/mysensors/MySensors/blob/development/Makefile
make cleanconfigThe red error led is always lit, no blink, just steady burn
Insn't that beacuse you configured --my-leds-blinking-inverse ???
-
Morning all.
Ive just had to completely rebuild my openhab and mysensors set up. Im running OH 2.4 on a Raspberry Pi 3B+, with the MySensors 2.4 bindings. Gateway compiles and runs fine....butttt I acidentaly configured --my-leds-blinking-inverse. How do i unconfigure it.Second led issue. The red error led is always lit, no blink, just steady burn. It is wired as noted in the guide.
Should i reneter the options and then remake the gate way? Im not sure how to go about this I was using arduinos before and there you just deleted the options from the sketch and reloaded it.
Thanks for the advice in advance
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login