@NeverDie Yeah, but when I priced out domestic places, they all wanted enough that the client just decided to go a different way. This was only going to be for a prototype, but even so, I got prices ranging from I think $10-50 per pin holder, and it was less than 2 grams of plastic each. I just checked again, and JLCPCB would do them for $1 each, and then $20 for quick shipping, and as low as $4 for the slow boat that takes a month. None of those options were very appealing at the time.
Digikey wants $13.66 each for this when I pick qty 10, so still not worth it for this project. Shipping with them is free, but I have no idea how quick they would be.
I also checked PCBWay, just for fun, and they quoted 1.24 at qty 10, for $12.45 total. Interestingly, the quote for 1 was $12.45 also. They wouldn't show an estimate for shipping without clicking the 'Submit' button and having a human engineer review the file for printability. Since I'm not actually going to do this now, I don't want to waste their time, so I don't have a total price from them for comparison.
As far as OP, this is a very old thread from 3.5 years ago, so I doubt that they still need help.
@evb my bad. The nodebb admin interface has a "Save" button that I didn't see so the changes I made were thrown away. I've re-entered the settings ans this time I clicked Save
To fix, first clean the nozzle to look like new from the outside. Next heat up the nozzle to temp and apply pressure to the filament with your fingers, usually this will push through a clog. If you cannot manually push filament through, consider replacing the nozzle or entire hotend.
