Most likely you are right, nevertheless, all my simple devices are working correctly, the only problem that I have encountered is a problem when flashing some controllers through the USBASP.
Hey @ejlane! Many thanks. I didn't see your message from a while ago (don't seem to get these in my email). I just ordered the PCB at JLCPCB.com. Worked great! Thanks again. Looking forward to building this gateway.
@NeverDie said in The Harvester: ultimate power supply for the Raybeacon DK:
Edit: This guy found another couple of possibilities as to what the E50D chip might be: https://www.electroschematics.com/pfm-module-circuit-surgery/
I have the same board as this guy. I removed the LED and resistor because they are on the input side, so they are almost useless anyway. For a board such as this, with a promised 0.9v startup voltage on the input side and a promised 5v on the output side, they really should have been attached to the output, not the input, to show roughly when it is that the board is producing useable output.
At a 20mv "keep alive" input voltage, the input measures 0.5ma using a uCurrent Gold. That means the keep alive energy is 10 microWatts. Offhand, for the application we've been discussing on this thread, I suspect that number is too high to be practically useful, because at only 20mv input we'd be collecting far less than 0.5ma current from a tiny panel. At least now we know.
Sorry, one more mistake. On the board, the UART port connector rotates on 180 degrees. In this case, UART on the Orange PI Zero and UART on the board should be connected with wires.
RFM69 and Ethernet shield share SPI bus, each one with its own CS line. Ethernet shield uses pin 10 so JP1 should use pin 6 for the radio. Issues sharing SPI bus seems to be due to bad SEN line handling as described here. The official Arduino ethernet shield suffered from this, but most commonly used clones work ok. Shields including 74LVC14 as in the pic should work ok.
