Extend footprint pads beyond nRF5 module; bad practice?
ncollins last edited by Yveaux
I want to extend the footprint pads beyond the edge of this non-castellated nRF5 module, so that I have a chance to hand rework any soldering issues. Is this bad practice? Will the solder mask on the module cause issues?
Appreciate any feedback, thanks.
skywatch last edited by
@ncollins It will add a tiny bit more capacitance between the pads, but I doubt it will be enough to cause any issues. Especially compared to the track routing on the board which will have much more affect on operation.
ncollins last edited by
@skywatch that's good to know, thank you