HI. I use this sketch to my lisght but in Home Assistant it show me it as SWITCH. Is any chance to change it in mysensors sketch to show in Home Assisnatnt as LIGHT ?
Hi,
Thank for your reply. Yes, i run since many years with a serial Gateway connected with my PI.
I thought it was possible to use the same machine to remove this extra element.
If you had a stability issue, I would just stick with my current formula and not change everything for now.
Regards,
@badisensors I have this same issue and am struggling to find a consice answer to the question. Have you figured it out?
I would love to see a bit more detail about the important naming and numbering protocals for Gateways, Nodes, Sensors, and their output values within the MySensors architecture. So far, I am not finding much and progress is slow when I simply need to try different iterations and make conclusions/adjustments.
Figured it out. I had to send HVAC_FLOW_STATE to HA, in order for it to figure out that it was a "thermostat". Only problem is that it shows up with states "Auto" "Cool" "Heat" and "Off" in the dashboard, even though I only have the possibility to heat, or turn it off.
I like the joke : )
I'll try to keep it simple. Most of my sensors are just reporting temperature and humidity. Since I can assign them to a room in home assistant. They don't need anything fancy.