LGT8F328P and MySensors
-
I bought some of the LGT8F328P arduino "clones", since they have some improvements over the normal nanos.
Unfortunately they did not work with mysensors. The serial output was nonsense.
Is it possible to use them for mysensors? how is that possible?
Greets patrick
-
@paede said in LGT8F328P and MySensors:
LGT8F328P
There are some instructions on this page? Here's another link that might be helpful.
I know nothing about this device other than the google search I just did on. Some red flags went up for me. The use of software for the third party board, and a newbie extoling its virtues. (astroturfing)
Even if you get it running, it may not work with MySensors. I bought three official Nano Every's with your same hopes and expectations. It claimed to be a direct replacement/upgrade. First, the MySensors nRF24 software did not work. Then I was unable to find a reliable way to put the Every into deep sleep.
I've had pretty good luck with the Nano clones on AliExpress. I'd recommend getting the RF Nano because the radio is built in. Before I put one into production, I spray it with electrical lacquer to prevent corrosion. That said, as with everything else you get on AliExpress, caveat emptor.
It will be appreciated if you get it working and present the details here as to how you did it.
-OSD
