My first 3D printed PIR enclosure
-
been tinkering away for a little and loving this project.
decided on the need for a nice enclosure for my 1st PIR project, at this stage only PIR.. plan for temp, and any other suggestions... its a screw top, so base will be screwed to ceiling, when batteries need replacing, just unscrew cap and change.
Attached are the STL's for all with access to a printer and keen on giving it a crack... love your feed back, and or sketch with temp and anything else...
PIR_V4_Base.stl
PIR_V4_Top.stl
enjoy
its a
-
Wow,
Good job. The batteries are too big
-
@Ashley-Savage Nice Job... Where are the mounting holes for the base?
-
I should get a 3D printer.
My PIR is just a board at the moment as I've not been able to find a good enough box.
-
1 out of 5
Suggested Topics
-
Pass reset on forum
General Discussion • 16 Apr 2014, 06:49 • Dvbit 17 Apr 2014, 03:28 -
Best 3d printers
Enclosures / 3D Printing • 8 Jun 2019, 09:52 • Crumpy10 20 Jan 2023, 20:57 -
3d hubs alternative?
Enclosures / 3D Printing • 19 Nov 2018, 19:20 • sundberg84 15 May 2022, 00:15 -
3D printed housing for an MQTT-GW
Enclosures / 3D Printing • 21 Dec 2020, 11:21 • bgunnarb 3 Jan 2021, 18:53 -
3d printing for accessories designer
Enclosures / 3D Printing • 8 Jan 2021, 11:01 • laurabarreda 25 Apr 2023, 03:37 -
Is there a 3D printable enclosure for RPi 4 w/ serial gateway?
Enclosures / 3D Printing • 30 May 2020, 01:29 • Kikakee 19 Aug 2020, 02:43
