Error Compiling Ethernet Gateway

[clippermiami]

Please bear with me, i'm new to Arduino.

I'm trying to compile the EthernetGateway sketch having made the changes for my IP address and Port. I get the following error:
'IPAddress' does not name a type

Per the instructions I'm trying to change the IP address and port to:
#define IP_PORT 5001 // The port you want to open
IPAddress myIp (192, 168, 15, 118; // Configure your static ip here

[hek]

@clippermiami

There is a missing end-parantesis in your posted example.

IPAddress myIp (192, 168, 15, 118**)**;

[clippermiami]

Well, Duh

[clippermiami]

@clippermiami
That was a copy/paste error --- the actual line was and is:

#define IP_PORT          5001  // The port you want to open 20140404 JRS
IPAddress myIp (192, 168, 15, 118);  // Configure your static ip-address here 20140404 JRS

And I still get the error in compile IPAddress does not name a type

This is the Ethernet Gateway code as downloaded from the site, the only change is to substitute the port number and the IP address fields

[hek]

@clippermiami

Are you using the ENC-module or WizNet?

If ENC, Try removing the src-folder from the UIPEthernet-library.

[clippermiami]

@hek
The ENC module so i'll try your suggestion today and reply when I have results

[clippermiami]

UIPEthernet

I removed the "src" folder and still got the same error "IPAddress does not name a type"

#define IP_PORT 5001 // The port you want to open
IPAddress myIp (192, 168, 015, 118); // Configure your static ip-address here

[hek]

IPAddress does not name a type

@clippermiami

You must have done something wrong when installing the libraries. It works fine for me.

[clippermiami]

Well, I'll reinstall then and get back to you. Thanks

[tigra]

@clippermiami I had the same issue when the libraries weren't in place. See the steps at: http://www.mysensors.org/build/arduino

[clippermiami]

@tigra I got it working and in my excitement I forgot to follow up here.

I don't have the Ethernet Gateway working but the Serial one is running along with a single DHT sensor for now so I'm happy

john

[A Former User]

does someone solved this fault also for Ethernet Gateway? While trying to adapt Sensebender Gateway to Ethernet, I get following messages:
error: 'IPAddress' does not name a type IPAddress _ethernetGatewayIP(MY_IP_ADDRESS);
error: 'EthernetServer' does not name a type
EthernetServer _ethernetServer(_ethernetGatewayPort);

followed by some more, expected to result from the above mentioned.