RFM75 POWER DOWN MODE ISSUE
-
I am setting RFM75 to power down mode by doingthe following:
CE low
Set power down bit to 0.
CE high.then later on I power up the chip using:
CE low
Set power down bit to 1.
CE high.then I set chip to transmit mode using your set to tx mode code example.
I send data through TX Fifo and get an interrupt back (INT0 in atmega) and I read the status register which shows 0x2E hex value. This tells me data was sent though fine.But the receiver RFM75 on the other hand does not receive the message.
If howeever I never put the RFM75 transmitter in power down mode, the whole process of sending data works fine. The issue is only when I set RFM75 transmitter to power down and wake it up and send data.
-
I know Its too late to ask you, but did you find the solution?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login