Ethernet GW with Nano v3 : Voltage issue

[djolafritte]

Hello Experts,

I'm new in arduino and MySensors stuff.

I want to build my Ethernet Gateway. I did it with Arduino Nano V3 (Nano DCCduino MEGA 328p) and the Ethernet ENC28J60.

My problem is when I connect my ethernet cable, the ethernet LED didn't blink as normal. Furthermore, when I measure the voltage on the board I see 2.28V not 3,3V.

Am I the only one who has this issue ?

PS: sorry for my english.

Regards

[soward]

I have the same setup, and it works okay, voltage sits around 3.2ish volts in operation when powered via USB. If your power supply is adequate, perhaps it's just a bad Nano?