LM393 remove LEDS
-
Hello all,
Is it possible to cut the LED's on an lm 393 circuit board. t has two leds.
one is connected to a digital output and the other one is the power LED.
in my sketch i use the Analogue output.Thanks in advance
-
@derksuh To be absolutely sure I'd have to see the board or the schematics.
Most probably both LEDs are only used to give a visual feedback of the state of the digital output and the power supply, and have no other function in the circuit.
If this is the case, you can safely remove them.
-
If you are using the analog output you might be able to remove the lm393 and the pcb it is mounted on entirely. Like I did on my plant monitoring as described in https://forum.mysensors.org/topic/2147/office-plant-monitoring/21
3 out of 3
Suggested Topics
-
Over the air updates
General Discussion • 23 Mar 2014, 21:38 • ToSa 1 Mar 2015, 11:21 -
Does MySensors require Arduino Timer 2?
Hardware • 6 Jan 2024, 19:39 • OldSurferDude 11 Jan 2024, 04:39 -
Arduino Nano Every problem
Hardware • 1 Feb 2020, 09:18 • hakha4 5 Dec 2023, 02:21 -
Best VOC sensor for detecting a wide range of VOC's?
Hardware • 26 Oct 2023, 23:59 • NeverDie 18 Nov 2023, 01:41 -
hlk-pm01 are to noisy for rfm69?
Hardware • 5 Aug 2023, 21:16 • Tmaster 9 Aug 2023, 16:28 -
"Remote Irrigation with LoRaWAN: LM27313 Challenges and PCB Design"
Hardware • 24 Jan 2024, 23:06 • wrendral 3 Feb 2024, 07:13
