UNO3 with ATMEGA8A-PU
-
Hi
I have an above clone and was trying to upload the sketch for the relay module.
In the compiling it tells me that I need toPlease ensure chosen MCU is either 328P, 32U4 or 2560
Is it not possible to use that chip?
-
Unfortunately I think that the memory is to small on that device. It only has 8Kb of flash, whereas the 328 has 32Kb. Actually the 328 is (more or less) a atmega8 with 32Kb flash instead of 8 (same pinout, if my memory is correct)
/ Thomas
1 out of 2
Suggested Topics
-
Over the air updates
General Discussion • 23 Mar 2014, 21:38 • ToSa 1 Mar 2015, 11:21 -
Sleep mode for bmp280
Hardware • 20 Feb 2018, 13:24 • fishermans 5 Feb 2024, 18:30 -
Sensor to detect marijuana vape/smoke
Hardware • 21 Jan 2025, 06:36 • Hellmark 25 Feb 2025, 20:56 -
Newbie questions
Hardware • 14 Feb 2025, 20:03 • magwas 14 Feb 2025, 20:03 -
Arduino Nano Every problem
Hardware • 1 Feb 2020, 09:18 • hakha4 5 Dec 2023, 02:21 -
Does MySensors require Arduino Timer 2?
Hardware • 6 Jan 2024, 19:39 • OldSurferDude 11 Jan 2024, 04:39
