V_WEIGHT doesn't show up in devices
-
I can't get domoticz to create devices for nodes sending v_weight but v_hum or v_temp works! In the hardware tab I can see the child node with weight getting updated like it should, but in the logg in domoticz the weight messages are not shown.. does anyone have an idea on what's wrong?
I have my sensors 2.1 and radio connected to gpio on a rpi.
-
@jonken v_weight still may not be implemented in Domoticz perhaps. At least back in November it wasn't according to
this postYou may be better asking over there for an answer.
-
Thank you, I'll investigate that further and get back!
3 out of 3
Suggested Topics
-
Vera Gateway Versions
Troubleshooting • 29 Mar 2014, 19:59 • karenbobiv 30 Mar 2014, 07:20 -
Node update on value from Domoticz
Domoticz • 30 Jul 2023, 19:19 • zboblamont 7 Aug 2023, 14:33 -
S_GAS, send and request problem
Domoticz • 28 Nov 2024, 05:38 • Marcin 28 Nov 2024, 05:38 -
Calculate Delta T of two temperature sensors with lua
Domoticz • 5 Oct 2022, 10:06 • Mela 5 Oct 2022, 10:06 -
Questions about an old setup
Domoticz • 4 May 2022, 02:55 • dbemowsk 9 May 2022, 17:30
