Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

[SOLVED] Anyone a working example of the combination NewPing 1.9 and MySensors 2.2.0 ?

GertSanders Hardware Contributor last edited by GertSanders

Does anyone have a working example of the combination NewPing 1.9 and MySensors 2.2.0 ?

I keep getting distance = 0, while the basic distance sensor sketch works perfectly (on the same setup), so the hardware side is OK.
Reply Quote 0
1 Reply Last reply
GertSanders Hardware Contributor last edited by @GertSanders

@gertsanders [SOLVED]: a wrong type in a declaration gave constant '0' values. Now corrected and distances is now measured correctly.
Reply Quote 0
1 Reply Last reply

2
Posts

632
Views

Log in to reply

Suggested Topics

Mysensors 1.5 and NRF24L01 without +
Troubleshooting • nrf24l01 radio init without + • • Floca

5

0
Votes

5
Posts

1859
Views

Yes its for an Sony Product, because i tested around a bit. The IP is unique and the mac was also tested with DE:AD:BE:EF:FE:ED with no results
Can't get the RFID working.
Troubleshooting • • jonehr

1

0
Votes

1
Posts

560
Views

No one has replied
New to this and frustrated with the arduino IDE
Development • • ewaldsreef

15

0
Votes

15
Posts

3749
Views

@jeylites I just put mine into My Documents/Arduino/Libraries
UI7 and Mysensors - lots of problems
Troubleshooting • • Alexander Ivanov

4

0
Votes

4
Posts

1410
Views

@hek I am seeing a lot of st=fail on my nodes. I have added a 4.7uF capacitor between ground and VCC but that did not help. What should I try next? a bigger capacitor? I am using an iphone wall charger as power source. Thanks!
Mysensors stopped working on Vera
Troubleshooting • • johnr

10

0
Votes

10
Posts

3027
Views

Im not home right now but gateway is v 1.5 and almost all sensors is also 1.5 recept 1 or 2 at 1.4.. Distance vary alot between 1 to 50 meters from the gateway. I've traced the problem to the gateway though, it loses connection to my Vera for some unknown reson
MySensors gateway running as a service
Development • gateway • • OldSurferDude

4

0
Votes

4
Posts

27
Views

@mfalkvidd Thanks, I didn't see that! OSD
More relay and push botton
Development • relay remotexy • • Gabriele Cirillo

16

0
Votes

16
Posts

1898
Views

ahhhhh! no, I start from 0 with an example found on the web, the @korttoma sketch is too complicated for me
MysensorListener - a webpage that shows messages between Vera3 and Mysensors gateway
My Project • • timdows

1

3
Votes

1
Posts

1087
Views

No one has replied

33
Online

11.7k
Users

11.2k
Topics

113.0k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1