Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Water Flow Sensor with SonOff

Bur Han last edited by

Hey !! Can anyone guide me about how to get water flow pulses from sonoff GPIO14 ?
Reply Quote 0
1 Reply Last reply
Bur Han last edited by

no one ??
Reply Quote 0
1 Reply Last reply
bjacobse last edited by

Did you try the below forum?
http://support.iteadstudio.com/support/discussions
Reply Quote 0
1 Reply Last reply

3
Posts

926
Views

Suggested Topics

FOTA using OptiBoot copy_flash_pages
Development • • eiten

1

0
Votes

1
Posts

9
Views

No one has replied
MYSBootloader + STM32 with Ethernet module
Development • • Marcin

2

0
Votes

2
Posts

13
Views

I'm afraid, the MYSbootloader is only available for the AVRs.
MySensors Gateway on OrangePi 5
Development • • mauri

5

0
Votes

5
Posts

29
Views

Thx for the hint. Unfortunately this didn't help me to find a solution for the compilation error. I simply don't understand the lines 105 and 106 in (MyHwLinuxGeneric.h). Can anyone explain me the C magic going on there? #define ATOMIC_BLOCK for ( ATOMIC_BLOCK_CLEANUP, __hwLock(); \ __atomic_loop ; __atomic_loop = 0 ) I think the problem is the "new"/different compiler version being used on the OrangePi 5. On my Raspberry Pi the code compiled without any problem.
MYSBootloader
Development • • omoX5

2

0
Votes

2
Posts

20
Views

No. For RFM69 you need Sensbender bootloader and external flash. Then it works.
NRF24L01+PA+LNA power down question
Development • • Dan Mincu

8

0
Votes

8
Posts

600
Views

@Dan-Mincu Hello I am looking for help because I have the same problem. Can you show me the code you use to set power down radio?
MYSBootloader 1.3 pre-release & MYSController 1.0.0beta
Development • ota myscontroller mysbootloader • • tekka

198

13
Votes

198
Posts

84981
Views

@tekka Is there any changelog to it also or it was just made officially available again? although last online status was 22 AUG 2020, so anyone else can confirm anything about it? I'd just be cautious without confirmation.
problem with Dallas temperature
Development • • mickaelr30

3

0
Votes

3
Posts

16
Views

hello, I just deleted the eeprom but I still have the problem.
How control W5500/W5100 (with STM32) by mysensors library
Development • • Marcin

2

0
Votes

2
Posts

16
Views

I found procedure gatewayTransportInit(), it works great. However, I cannot find a procedure that will enable detection of a network connection at level mysensors. I noticed that disconnecting the network plug or resetting the W5500 (37 pin to ground) changes the device's IP address to 0.0.0.0 - then I call gatewayTransportInit() - but mysensor's library must have such procedures - please tell me how to diagnose ethernet connection.

Water Flow Sensor with SonOff

Suggested Topics

FOTA using OptiBoot copy_flash_pages
Development • • eiten

MYSBootloader + STM32 with Ethernet module
Development • • Marcin

MySensors Gateway on OrangePi 5
Development • • mauri

MYSBootloader
Development • • omoX5

NRF24L01+PA+LNA power down question
Development • • Dan Mincu

MYSBootloader 1.3 pre-release & MYSController 1.0.0beta
Development • ota myscontroller mysbootloader • • tekka

problem with Dallas temperature
Development • • mickaelr30

How control W5500/W5100 (with STM32) by mysensors library
Development • • Marcin

61
Online

11.1k
Users

11.1k
Topics

112.5k
Posts

Water Flow Sensor with SonOff

Suggested Topics

FOTA using OptiBoot copy_flash_pages Development • • eiten

MYSBootloader + STM32 with Ethernet module Development • • Marcin

MySensors Gateway on OrangePi 5 Development • • mauri

MYSBootloader Development • • omoX5

NRF24L01+PA+LNA power down question Development • • Dan Mincu

MYSBootloader 1.3 pre-release & MYSController 1.0.0beta Development • ota myscontroller mysbootloader • • tekka

problem with Dallas temperature Development • • mickaelr30

How control W5500/W5100 (with STM32) by mysensors library Development • • Marcin

61Online

11.1kUsers

11.1kTopics

112.5kPosts

FOTA using OptiBoot copy_flash_pages
Development • • eiten

MYSBootloader + STM32 with Ethernet module
Development • • Marcin

MySensors Gateway on OrangePi 5
Development • • mauri

MYSBootloader
Development • • omoX5

NRF24L01+PA+LNA power down question
Development • • Dan Mincu

MYSBootloader 1.3 pre-release & MYSController 1.0.0beta
Development • ota myscontroller mysbootloader • • tekka

problem with Dallas temperature
Development • • mickaelr30

How control W5500/W5100 (with STM32) by mysensors library
Development • • Marcin

61
Online

11.1k
Users

11.1k
Topics

112.5k
Posts