Hi Awi, thanks for your answer! As you can see on my previous photos I have already connected the reed switch to my arduino on pin 9 and gnd after that I have typed pinMode (REED, INPUT_PULLUP); on my skecth. Following one of the project i have found which says
flipping the bucket a couple of times, I should see the counter in my serial monitor click-up, if not check the wiring. Therefore after following these instructions I can see no signs at all. I was wondering if my conexion to the reed switch is done correctly or it may be affected to my windows (Im working with windows 10) I see a clicking in my arduino board after uploading the sketch but I see nothing when flipping the bucket in order to track the movement of the tipping bucket.
