@heinz Please help me out. I am using bme680 just for humidity and temperature and trying to run code on code composer studio without activating the gas registers.Problem is that where are the data calibration registers.I am getting the temperature results correct but humidity results are completely terrible. I am getting the values of humidity like 0% then 100% then -1.35% then 0 the 1.8%

Kindly provide some help. I am using msp430 launch pad and I2c protocol to communicate between sensor and controller.

I am working on BME680 to interface with the MSP430launch pad having microcontroller MSP430G2553 using I2C interface. My code is not working correctly and I am getting the wrong readings. May be there will be problems in compensation parameters. I tried the almost similar code on BME280 and it was working fine.

Online code available at Github is only for arduino and I have checked it is working on my sensor adafruit BME680 board interfaced with arduino.

Please someone can help me.