I had to use a microscope but is says S08

Hello Everyone,

I have started a project to extend my Vera network and add some sensors. At the moment I am at the testing part using the 1.4 version. I am going to use 3 gateways 1 at each Vera I have. Currently I have setup 1 sensor using a Pro Mini 3.3V powered by a C123a Battery because I want to test the life time of these batteries. I have done all the hacks needed to power with battery so everything is working fine. But I noticed one very strange problem. I have setup a 900000ms sleep time which is supposed to be 15min, but I measured it around 7.5min. I am pretty sure that I compiled the sketch using 3.3V version. It seams that the timing is calculated with 16Mhz instead of 8Mhz. Is this possible?