Hello Friends,

I not a hardware guys and very new to electronics world. learning with the help of the forum and thankful to all the members for solving my hardware problems time to time.
I just read about ATmega2564RFR2, not sure where to start and wanted to check with all of you, is it compatible with current mysensors lib?

More info about ATmega2564RFR2

Thanks and Regards
Brij

@sundberg84, gr8 job done....really amazing to see this one. i want to make few sensors for my home. Is the design of the board is final? Kindly guide me for the placement of LE33 and Dallas Temp as mentioned in your BOM that placement "solder Le33 + Caps (1,0, 10uf) on the pcb underside. Note the directions of the LE33 (not as silk mask!)"

Also, will it be possible for you to upload the design to http://dirtypcbs.com, as i don't have any knowledge about PCB manufacturing. it will be very easy for me to order and get the PCBs for assembly.

I am very new to all this and learning from you guys.....

Thanks
Brijesh

@novicit, Thanks a lot for your help. i will make a new board as per your guidance and share the photos soon.

Regards
Brijesh

@the-cosmic-gate, greetings to you. Kindly let me know, is there any issue with the component placement in the board. Not sure why it's not working :(.

Thanks
Brijesh

Thanks a lot for your response, this is what i have done so far.

Hello everyone,

This is a gr8 project, i am looking forward to make few sensor for my home. As i don't have any experience with electronics and very new to all these terms and components.
I would request anyone of you to, kindly post some pictures of the board with components in place that i can copy and make my boards.
**Specially 3 pin regulator and Capacitors **

My first assembled board is not working, it looks like m doing something wrong with either the capacitors or the regulator. I checked my NRF24l01 VCC pin and not getting any voltage at all.

Please help me guys......

Thanks and Regards
Brij