Wow... Thanks for the link, this will come in really handy, I'll keep working on it..

Thanks!!

Ahhh.. That worked!!! Thank you very much!!!

Hi all,
I was wondering if there is a way to calibrate the MAX6675 ? I have two and both of them seem to off by 20 degrees.. Possibly this is the best accuracy I can expect, not sure I have never used them before..

Thanks!!

Ahhh.. That worked!!! Thank you very much!!!

Hi
I'm trying to figure out when I open my serial monitor on my Pro Mini's I get a scrambled response.. I have had it working before but I tried a new sensor upload (numerous) and now I'm getting crazy responses any help would be greatly appreciated!!
Thanks!!!!

Thanks for the reply... I'm guessing from the reply the error message doesn't matter?
I actually loaded an older version of Arduino that I had been using previously and now I no longer get the error message.
Thanks!!

Hi all,
After trying to upload code to a Nano I'm getting "Invalid version found: 1.04" message in error message window.. Using Windows 7.. Any help would be much appreciated!!! Thanks!!!

Hello
Was wondering if anyone can help me on fixing this error message that is appearing at the top of the page when I log into my VERA controller? The system was working fine and then all of a sudden it stopped working. I have tried all the usual things, rebooting, reloading luup.. Connected directly to the gateway and the nodes and they are working as expected, and are reporting to the gateway. Using a serial gateway. I have also, reluctantly, downloaded the new firmware version: 1.7.2043 to the VERA.. I'm pretty sure the top error (GET LANG)message has nothing to do with the comm error just because that was showing up long before the comm error showed up.. Any help would be much appreciated Thanks!!!

Seems I finally got it working, I'm wondering if there is a way to show the open or closed "live" status on the device page? I can get emails sent as a notification but I would like to see the door status on the Vera Web page when I log in from my phone.. Thanks!!!

Wow... Thanks for the link, this will come in really handy, I'll keep working on it..

Thanks!!

Wondering if anyone has an idea, Im trying a binary switch sketch, I have the node connected to my Vera Edge. The node shows up on the devices page but I'm not sure how the open/closed status is suppose to show on the Vera device page... Here is what the serial monitor is showing when I start up the switch, I'm wondering what the "fail" status is all about?

Thanks!!