I had the same problem, I straightened out a set of angular headers, then soldered them into the board, and bend them at the place I needed.
Not the best solution, but I had to many standard angular pins to go and buy more.
cvanandel
@cvanandel
Best posts made by cvanandel
Latest posts made by cvanandel
-
RE: 💬 jModule
-
RE: 💬 jModule
@Qu3Uk
I do not think that pad goes anywhere either, here is the Eagle layout picture.Regards
-
RE: 💬 jModule
I have not, nor do not claim to have designed this module, the module was designed by julisses.
All credit for this board goes to julisses.
The only thing i did was to send his .brd file to OSH Park, so there was a local company we could order the board from.
So if there are any changes required to the board, please contact julisses.Sorry if there was a misunderstanding.
-
RE: 💬 jModule
@Dwalt
Pin 8 on the Module is Ground, and Pin 7 is VCC, these Pins do not get connected to the Mini Pro
But they come out the side on the angle connector as IO -
RE: 💬 jModule
@AWI
I just checked the board is now available under shared projects. -
RE: 💬 jModule
I had forgotten to Share, I just did, so give it a little time, and the system should update.
-
RE: 💬 jModule
I have uploaded the .brd file to OSH Park pcb manufacturing company.
you can sign up with them, and search for jModule.
and order the board for $3.20 for 3 boards
Hope this helps somebody.
Regards
cvanandel