I had the same problem, I straightened out a set of angular headers, then soldered them into the board, and bend them at the place I needed.
Not the best solution, but I had to many standard angular pins to go and buy more.

@Qu3Uk
I do not think that pad goes anywhere either, here is the Eagle layout picture.

Regards

@aproxx

I have not, nor do not claim to have designed this module, the module was designed by julisses.
All credit for this board goes to julisses.
The only thing i did was to send his .brd file to OSH Park, so there was a local company we could order the board from.
So if there are any changes required to the board, please contact julisses.

Sorry if there was a misunderstanding.

@Dwalt
Pin 8 on the Module is Ground, and Pin 7 is VCC, these Pins do not get connected to the Mini Pro
But they come out the side on the angle connector as IO

@AWI
I just checked the board is now available under shared projects.

I had forgotten to Share, I just did, so give it a little time, and the system should update.

I have uploaded the .brd file to OSH Park pcb manufacturing company.
you can sign up with them, and search for jModule.
and order the board for $3.20 for 3 boards
Hope this helps somebody.
Regards
cvanandel