yes, trank you.
I now know

No, already researched enough on this page

I believe that now I understood the concept.

It is then necessary to have a hardware sensor data (Arduino nRF24L01 + + ldr). This hardware will send to the gateway (Arduino + nRF24L01 +).

For the user to view the measurement it must have a "controller" installed on your computer or on a Socs (Raspberry).

Am I correct in my understanding?.

OK thanks.
But I can use the Arduino as this driver? For example when I am with the data with a serial gateway, I can see the value that comes from sensors linght module.

I have experience in using the mesh with the TMRH20 library (RF24). And in it there is a specific controller.

My big question of mysensor and creating (Sensor + gateway + controller). Would have some tutorial to be followed?

Hi guys , I'm new in the world of mysensores . And I'm sure of that really need to promote communication between the following hardware.

sensors .:
Arduino , NRF24L01 + and I am using the logical name of IDE : linght sensor.

gateway .:
Arduino , NRF24L01 + with serial interface.
Running serial Gateway code.

My doubt and if I need to add anything else to work as descriptions