MQQT Gateway works with V1.4.1, SoftSPI enabled in RF24_config.h and workaround mentionned (#define digitalio.h in main ino) but radio dialog with nodes in V1.4.1 fails (for Nodes , SoftSPI is not enabled). If i rollback nodes to V1.4 , it works!

Yes, I did the gateway upgrade to V1.4.1 . I'm using Mqtt Gwy.
i've tried also to used SofSpi but get the same problem as mentionned in an another post (compil error in RF24.h) . I've let my Mqtt Gateway in V1.4.1 but not with softspi , using ports 11,12,13 instead of A0,A1,A2.
I've rollbacked all my nodes to V1.4.
So my config is now : Nodes V1.4 + Gateway V1.4.1 , all run fine.

You say that V1.4.1 is only a BugFix release but , for example, SofSPI was not present in V1.4 but only in V1.4.1. Maybe other differences ?

Hi,
I've a lot of nodes built with V1.4. All are running fine.
I downloaded V1.4.1 but since some of them seem hanged. . I get only "node started" but nothing else.
No error message.
I've restored V1.4 and all run fine now.

Any Idea ?

Thanks.

So, connected less protocol (Http,udp,..) couldn't be used with this basis sketch. As i'm looking for a Http interface with Imperihome , i'm interrested by any idea about how to.

Thanks

In the Ethernet gateway Sketch, there is a callback routine writeEthernet with just one command"server.write(writeBuffer);" .
But i don't understand how to specify IP and port destination and thru which protocol (TCP,HTTP,UDP,..).
Any idea ?

Regards