Posts made by Jason Campey

i dont have a capacitor connected might be that.. Have dont the same thing from a nano and seemed ok.

I am using the NRF+.. checked the VCC pin voltage and its outputting 3.3v its using the pro mini onboard regulator.

Hello Gurus..

Have an issue I was hoping I could get some help on..

Have a pro mini 3.3v

Supplying power via raw pin 3.7v or 6v seems fine until I connect the radio to VCC as well
Then it looks like no power is getting to the board at all.. Disconnect radio from VCC and board looks like it is getting power again.

Not sure what could be going on there