Sure. Openhab connects to mqtt gateway without any problems, but i dont know where to find node and sensor ID ex. for switch "mysensor:MyMQTT/nodeID/sensorID/V_LIGHT:command:ON", what i should put instead of nodeID and sensorID? where to find theme? is there any option i can get nodeID and display it when debugging (node) on com port?

i do have openhab... but it does not list anything. Can i make static nodeID?

Hi! How can i find node ids (mysensor:/id1/id2/V_LIGHT) when they are connected to mqttgateway or etherentgateway?

Hello! When i run scanner example on RF24, i see nothing else than zeros. I'm preety sure that i'd connected the radio module well. Does anyone know any issues? Thanks!

SPI device = /dev/spidev0.0
SPI speed = 8000000
CE GPIO = 25
STATUS = 0x0e RX_DR=0 TX_DS=0 MAX_RT=0 RX_P_NO=7 TX_FULL=0
RX_ADDR_P0-1 = 0xe7e7e7e7e7 0xc2c2c2c2c2
RX_ADDR_P2-5 = 0xc3 0xc4 0xc5 0xc6
TX_ADDR = 0xe7e7e7e7e7
RX_PW_P0-6 = 0x00 0x00 0x00 0x00 0x00 0x00
EN_AA = 0x00
EN_RXADDR = 0x03
RF_CH = 0x4c
RF_SETUP = 0x07
CONFIG = 0x0f
DYNPD/FEATURE = 0x00 0x00
Data Rate = 1MBPS
Model = nRF24L01+
CRC Length = 16 bits
PA Power = PA_MAX
000000000000000011111111111111112222222222222222333333333333333344444444444444445555555555555555666666666666666677777777
0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef0123456789abcdef01234567
000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000000
00000000000000000000000000000000000000000000000000

perferct! when you planning next relesase?

which modules are supported now?

very nice! i'll test it in this weekend. Any chance for RGB sliders?

Could anyone help me with running MQTTGateway with enc28j60 ethernet module? Should a gateway respond to ping? Openhab says 'no route to host'. Should i change anything else than Ethernet.h to UIPEthernet.h in source code ?