@iotcrazy It is Jeedom, you can find some information here: http://www.mysensors.org/controller/jeedom
It use an RPI2 if you ant to make it yourself, and a major version will come during the week !

I can't tell you for the moment, I haven't check the real voltage of the CR2032 at the beginning. I'll try to make two mesure between 30 days.
But my sketch is 1800000ms or 30min sleeping (if no-one press the button). Because it's a redundant information, my Jeedom controler have a meteo plugin who's working good. (i'll use it for the mini-night-temperature to have a message if there is glass on my car's windows).

My node doesn't work anymore. Even with new set of accus. I will check again when I'll solder it.

A week.
New accus i think. I do it again but this time, i'm making voltage report with my voltmeter and a picture.

Thanks for the complet answer !

I'm already at 2.73Volts on my two AAA batteries. Is the last sketch a batteries killer ? With a 10 hours sleeping ??

Isn't blacklisting cool too to use ?
Like, if we know the "name" of the sensor lost, we push it to the black list and voila ? This way, we don't have to put a long list a agreed sensors if we have only two nodes outside the house.
... I think.

Too bad, way out of my ability...

Thanks for the answer.
May we trick and use two arduino talking via serial ?
My controller doesn't support two gateway yet.

Hello everyone,
I would like to make a repeater with tow radio, because my gateway is 2.4Ghz, but i wan't to put outdoor sensors in 433Mhz.

BUT: as i'm not english native, i may haven't found the keyword to find this kind of project into the forum, is there anything like this ?

Thanks, and have a good day !