Hi there,

I have MyController running on RASPI with NRF24 Serial Module. This seems to work correct. Now I try to add a sensor to the system. I have tried several scripts from the MySensors Library. On the debug interface of the sensor I get this:

 __  __       ____
|  \/  |_   _/ ___|  ___ _ __  ___  ___  _ __ ___
| |\/| | | | \___ \ / _ \ `_ \/ __|/ _ \| `__/ __|
| |  | | |_| |___| |  __/ | | \__ \  _  | |  \__ \
|_|  |_|\__, |____/ \___|_| |_|___/\___/|_|  |___/
        |___/                      2.3.2

16 MCO:BGN:INIT NODE,CP=RNNNA---,FQ=8,REL=255,VER=2.3.2
28 TSM:INIT
28 TSF:WUR:MS=0
36 TSM:INIT:TSP OK
38 TSF:SID:OK,ID=100
40 TSM:FPAR
45 ?TSF:MSG:SEND,100-100-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
2054 !TSM:FPAR:NO REPLY
2056 TSM:FPAR
2060 ?TSF:MSG:SEND,100-100-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
4069 !TSM:FPAR:NO REPLY
4071 TSM:FPAR
4075 ?TSF:MSG:SEND,100-100-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
6084 !TSM:FPAR:NO REPLY
6086 TSM:FPAR
6090 ?TSF:MSG:SEND,100-100-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
8099 !TSM:FPAR:FAIL
8101 TSM:FAIL:CNT=1
8103 TSM:FAIL:DIS
8105 TSF:TDI:TSL

On MyController the gateway-setup is as follows:

Is it correct, that I can connect a sensor to the gateway without node? Or can I use a sensor as a node, too?