Navigation

    • Register
    • Login
    • Search
    • OpenHardware.io
    • Categories
    • Recent
    • Tags
    • Popular
    1. Home
    2. tonymac32
    • Continue chat with tonymac32
    • Start new chat with tonymac32
    • Flag Profile
    • Profile
    • Following
    • Followers
    • Blocks
    • Topics
    • Posts
    • Best
    • Groups

    tonymac32

    @tonymac32

    1
    Reputation
    2
    Posts
    21
    Profile views
    0
    Followers
    0
    Following
    Joined Last Online

    tonymac32 Follow

    Posts made by tonymac32

    • RE: 💬 Raspberry Pi Power Supply Board

      FYI, just tossed out a Rev 2 because I'd left out the mounting hole clearances for the plane and resist.

      posted in OpenHardware.io
      tonymac32
    • RE: 💬 Instrumentation Amplifier

      Hello everyone,

      Had a moment to put in a post, to let you know I could answer questions. I'll probably put a few more designs up here if I get any interest. The Github for the design will always be the most recent, but I will release revisions here if/when they need to happen.

      This board came about because I had need of a fast sampling strain gauge load cell circuit for a project. I designed this to be a prototype board to work between different MCU boards and with varying load cells.

      This circuit has been tested using 3 different Arduino form factor boards, the Uno, the Sparkfun ATSAMD21G breakout, and the Adafruit Metro M4 Express.

      0_1547329403428_IMG_20190112_161433.jpg

      I don't have the regulator populated in the image, I was using a wire jumper until deciding on which board this particular one would permanently reside, the Sparkfun board, for example, require a 5V v-in, whereas the Adafruit and Arduino can handle 12V.

      The 2.54mm pitch terminal blocks are spaced back from the edge of the board in case a smaller board is desired (to match the Sparkfun or Coridium board profiles), and to allow the use of a 90 degree pin header instead of the screw terminals without going off the end of the board.

      posted in OpenHardware.io
      tonymac32