Hey everyone,

I'm building my system from the ground up, so I started with the gateway. (MQTT in order to connect to openHAB)

Before making some nodes, I'd like to know if the gateway can be tested, by simulating some nodes. Is it possible to do so by sending Serial messages to the GTW on its serial?

Thanks in advance for your help,
Totony.

Fixed, thanks!!!!

Thanks for the quick answer!
I thought it was my first install of the lib, but I might have put it in my lib folder when I found out about MySensors.
So I just extracted there and replaced conflict. I'll remove the MySensor folder and extract again.

Hi everyone,

I have just installed the MySensor library:

• copied the whole content of the library folder in my arduino lib folder
• restarted the IDE (1.0.5-r2)

I tried compiling several MySensors exemples directly from the example menu and always get the same error:

M:\PRJ - Domotics\arduino\libraries\MySensors\Relay.cpp: In member function 'void Relay::begin(uint8_t, rf24_pa_dbm_e, uint8_t, rf24_datarate_e)':
M:\PRJ - Domotics\arduino\libraries\MySensors\Relay.cpp:23: error: 'EEPROM' was not declared in this scope
M:\PRJ - Domotics\arduino\libraries\MySensors\Relay.cpp: In member function 'void Relay::addChildRoute(uint8_t, uint8_t)':
M:\PRJ - Domotics\arduino\libraries\MySensors\Relay.cpp:220: error: 'EEPROM' was not declared in this scope
M:\PRJ - Domotics\arduino\libraries\MySensors\Relay.cpp: In member function 'void Relay::removeChildRoute(uint8_t)':
M:\PRJ - Domotics\arduino\libraries\MySensors\Relay.cpp:227: error: 'EEPROM' was not declared in this scope

I'm able to compile other sketches on that environment.

I didn't find that error on the forum, so I wondered if I had another Relay.h in my environment, which could conflict with yours, but it's not the case.

Any idea?

Thanks in advance for your help.

Totony.