openLuup

• 

  Howto connect OpenLuup to MySensors - detailled instructions, Please
  • techno819  

  2
  0
  Votes
  2
  Posts
  14
  Views

  

  @techno819 did you try the 43 page guide linked from https://www.mysensors.org/controller/openluup ?
• 

  Instructions to connect to MySensors
  • Homer  

  5
  0
  Votes
  5
  Posts
  838
  Views

  

  No prob! It's funny because I didn't realise that the original poster was me lol I ended up getting the Vera 3 working again.
• 

  openLuup - a Vera emulator for all platforms
  controller vera • • akbooer  

  13
  4
  Votes
  13
  Posts
  11466
  Views

  

  It's been a while since I posted here, but openLuup has continued development and is now a really very capable controller with extensive plug-in compatibility with Vera. Latest version always available from GitHub here https://github.com/akbooer/openLuup
• 

  Built an Ethernet gateway to connect with openluup running on RPI3 couple of issues
  • Galaxynik  

  2
  0
  Votes
  2
  Posts
  1144
  Views

  

  Just an Update Well after lots of trials it does look like this is in the AltUi plugin in OpenLuup, stopping Openluup with http://RPI_IP:3480/data_request?id=exit and then SSHing into the pi and reloading it with ./openluup_reload connects to the Arduino gateway without a problem and without the multiple reload of Luup. Clicking "Reload Luup Engine" from the misc menu in AltUi always results in multiple reloads 5-10 times. Changing an attribute of a device in AltUi prompts a single reload of Luup again connecting with the Arduino gateway fine without the multiple reload cycles regards Nik