Just an Update

Well after lots of trials it does look like this is in the AltUi plugin in OpenLuup, stopping Openluup with

http://RPI_IP:3480/data_request?id=exit

and then SSHing into the pi and reloading it with

./openluup_reload

connects to the Arduino gateway without a problem and without the multiple reload of Luup.

Clicking "Reload Luup Engine" from the misc menu in AltUi always results in multiple reloads 5-10 times.

Changing an attribute of a device in AltUi prompts a single reload of Luup again connecting with the Arduino gateway fine without the multiple reload cycles

regards

Nik

Using a uno R3 + W5100 Ethernet Shield + nRF24L01 Wireless Module w / PA and LNA + Mysensors Library 2.0. Once I'd found and removed the short circuit against the card slot on the w5100 connected the radio and sorted out a reserved i/p address the gateway gets up and running ok. I've created a Mysensors device on the openluup (using altui) - plug in version 1.5 (cant find anything later) with the correct i/p address and reloaded luup.

When it reloads it goes into a loop of multiple reloads - today it was 9 cycles of reload Luup always exiting with 42 because of a request by system here the last part of the lualog

2016-11-06 15:04:52.855 luup_log:16: Arduino: urn:upnp-arduino-cc:serviceId:arduino1,ArduinoLibVersion, 2.0.0, 16
2016-11-06 15:04:52.855 openLuup.server:: /data_request?id=reload tcp{client}: 0xed8448
2016-11-06 15:04:52.856 openLuup.server:: /data_request?id=lu_status2&output_format=json&DataVersion=390112047&Timeout=60&MinimumDelay=1500&_=1478428014656 tcp{client}: 0xd1a630
2016-11-06 15:04:52.856 openLuup.luup:0: device 0 'system' requesting reload
2016-11-06 15:04:52.857 luup.reload:0: saving user_data
2016-11-06 15:04:53.035 openLuup.luup:0: exiting with code 42 - after 0.0 hours

All the logs 1-5 are identical. This stimulates an immediate complaint from "wunderground" " API usage alert" requests 18 within the last minute

In the serial monitor of the Arduino I see 9 times in this case

0;255;3;0;9;Eth Connect
0;255;3;0;9;Eth 0;0;3;0;2;GetVersion
0;255;3;0;9;Eth
0;255;3;0;9;Eth Disconnect

After that it settles down - if I click start inclusion on the Arduino plugin in altUi I get

0;255;3;0;9;Eth 0;0;3;0;0;5;1
0;255;3;0;9;Eth

I'm assuming that this is ok but I am waiting for a couple of nano's to arrive and I have nothing to include atm

If I break the connection - Either by disconnecting the Ethernet cable or restarting the Arduino I have to reload openluup to re-establish connection and it goes into the reload cycle

Does anybody Have any idea what is happening and how I can get rid of the multiple reloads of Luup

Thanks

Nik