Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Howto connect OpenLuup to MySensors - detailled instructions, Please

techno819 last edited by

Re: Instructions to connect to MySensors
Reply Quote 0
1 Reply Last reply
mfalkvidd Mod last edited by @techno819

@techno819 did you try the 43 page guide linked from https://www.mysensors.org/controller/openluup ?
Reply Quote 0
1 Reply Last reply

2
Posts

14
Views

Log in to reply

Suggested Topics

Arduino based Distributed Clocks
General Discussion • • clippermiami

3

0
Votes

3
Posts

1529
Views

@blacey Thanks, looks like what I was looking for.
Instructions to connect to MySensors
openLuup • • Homer

5

0
Votes

5
Posts

838
Views

No prob! It's funny because I didn't realise that the original poster was me lol I ended up getting the Vera 3 working again.
openLuup - a Vera emulator for all platforms
openLuup • controller vera • • akbooer

13

4
Votes

13
Posts

11466
Views

It's been a while since I posted here, but openLuup has continued development and is now a really very capable controller with extensive plug-in compatibility with Vera. Latest version always available from GitHub here https://github.com/akbooer/openLuup
Built an Ethernet gateway to connect with openluup running on RPI3 couple of issues
openLuup • • Galaxynik

2

0
Votes

2
Posts

1144
Views

Just an Update Well after lots of trials it does look like this is in the AltUi plugin in OpenLuup, stopping Openluup with http://RPI_IP:3480/data_request?id=exit and then SSHing into the pi and reloading it with ./openluup_reload connects to the Arduino gateway without a problem and without the multiple reload of Luup. Clicking "Reload Luup Engine" from the misc menu in AltUi always results in multiple reloads 5-10 times. Changing an attribute of a device in AltUi prompts a single reload of Luup again connecting with the Arduino gateway fine without the multiple reload cycles regards Nik

57
Online

11.6k
Users

11.2k
Topics

112.9k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1