1.5.1 to 2.3.2 issues

[epierre]

Hello,

Today I migrated my gateway from 1.5.1 to 2.3.2, tested it fine.

Then I started trying to reprogram my sensors to 2.3.2 and none works. No wiring changed, previously fine working (CO2, DSM dust sensor)

16 MCO:BGN:INIT NODE,CP=RNNNA---,FQ=16,REL=255,VER=2.3.2
26 TSM:INIT
28 TSF:WUR:MS=0
34 TSM:INIT:TSP OK
36 TSF:SID:OK,ID=20
38 TSM:FPAR
41 ?TSF:MSG:SEND,20-20-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
2050 !TSM:FPAR:NO REPLY
2052 TSM:FPAR
2056 ?TSF:MSG:SEND,20-20-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
3899 TSF:MSG:READ,3-3-255,s=255,c=3,t=7,pt=0,l=0,sg=0:
3904 TSF:MSG:BC
4063 !TSM:FPAR:NO REPLY
4065 TSM:FPAR
4069 ?TSF:MSG:SEND,20-20-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
5923 TSF:MSG:READ,3-3-255,s=255,c=3,t=7,pt=0,l=0,sg=0:
5928 TSF:MSG:BC
6076 !TSM:FPAR:NO REPLY
6078 TSM:FPAR
6082 ?TSF:MSG:SEND,20-20-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
7947 TSF:MSG:READ,3-3-255,s=255,c=3,t=7,pt=0,l=0,sg=0:
7952 TSF:MSG:BC
8089 !TSM:FPAR:FAIL
8090 TSM:FAIL:CNT=1
8092 TSM:FAIL:DIS
8094 TSF:TDI:TSL

[mfalkvidd]

@epierre what does the log from the gateway say? Preferably for the same time, so the node side and the gateway side can be compared.

[epierre]

will try to put it in debug mode. now I've added a 1u and 100u with no result

[epierre]

intermediary result: I have started a second gateway and now the nodes do communicate... puzzled...

I remove the extra gateway... same situation...

so reprogram gateway with:
#define MY_RF24_PA_LEVEL RF24_PA_LOW

so it seems this was the responsible for this !

thanks !

[epierre]

Hello,

I am reviving this as I upgraded my kernel to 7.0 and now have communications issues.

I discovered that I had to force port speed when opening it up to the right speed, then it communicates a bit then nothing...

driver is ch341

any idea ?