Replace 2.4GHz remote controllers

[Zwippet]

Hi.
First want to say that I'm overwhelmed of the information on this site and don't know where to begin. This is why I'm placing this post.

Situation:
I own several Remote controllers to control a: IR Panel, LED ceiling lamp and LED AliExpress lamp (see picture). I thought to simply capture and replay the RF 2.4GHz signals with some to replace the Remote controllers. This to add some RF device to my Raspberry Pi with Home Assistant.

I came across this site: https://www.rflink.nl and bought a Arduino Mega 2560 and a NRF24L01 (see picture). I put it together but sadly I can't get it to work.

Than I came across this site and have hope again.
Questions:

• Should/Could it be possible to record and replay the RF 2.4GHz signals of the remote controls? Some are saying that that there are many protocols etc.
• Can I use my Arduino setup and some software from this site to accomplish this?

[monte]

@Zwippet the link you provided answers most of your questions:

That's the list of devices supported by rflink firmware. If yours aren't among them, I guess they won't work.

Mysensors work within it's own protocol and doesn't support any 3d party commercial products as per my knowledge.

[JeeLet]

@monte said in Replace 2.4GHz remote controllers:

"Mysensors fonctionne selon son propre protocole et ne prend en charge aucun produit commercial" yes

the beginning of a track can be useful for you ?
https://github.com/Yveaux/NRF24_Sniffer
https://arduino.stackexchange.com/questions/39348/decoding-2-4g-rf-remote-controller