Anybody else seeing - unstable nodes - Need restart every ~24-48 hours?

[andriej]

Running out of memory - that's the problem for most of programs/nodes.
I have this problem in one too, so I made a code to restart node every x hours.

[Joey Edelstein]

I have this on a number of nodes using different power supplies. I have measured the voltage in to the radio arduino. I also have have a decoupling capacitor of 4.7uF across the radio's 3.3V and GND.
While it could be a mem leak if that is the case it in the mysensor lib as my sketch is pretty basic and should be using constant memory .

[hek]

The library does not use any dynamic allocation. So I doubt it it a memory leak situation.

[RJ_Make]

@Joey-Edelstein said:

I have this on a number of nodes using different power supplies. I have measured the voltage in to the radio arduino. I also have have a decoupling capacitor of 4.7uF across the radio's 3.3V and GND.
While it could be a mem leak if that is the case it in the mysensor lib as my sketch is pretty basic and should be using constant memory .

Try a large cap, try 47uf

[andriej]

@Joey-Edelstein try posting a code here so we can look better, maybe it's one of libraries?
or interrupt? or something...

[Joey Edelstein]

This is the simplest sketch I'm using that is demonstrating the behavior I described:
https://codebender.cc/sketch:103465

[HarryDutch]

@Joey-Edelstein

Have a look here. Remove all Serial.print(...) and Serial.println(...) and try again. Or use Serial.print(F(....)).

[Joey Edelstein]

@HarryDutch said:

Serial.println(...) and try again. Or use Serial.print(F(....)).

interesting. I will give it a try. Thanks!

[Joey Edelstein]

Just a thought here but if Serial.print("This string that gets allocated every time this is called") and basically is a memory leak shouldn't samples be updated to use Serial.print(F(....)) so the unwashed masses (like me) don't make stupid mistakes?

In the meantime I have updated my most accessible node and will see if this solves my issues.

[hek]

The normal Serial.println() using char-array does not leak memory. The F()-version just uses less of the precious RAM by keeping the strings in flash.

So the F() is really good to use, especially if you're sketch is big.

[GaryStofer]

Maybe you can setup a RF sniffer as seen here http://forum.mysensors.org/topic/242/wireless-nrf24l01-sniffer-for-mysensors and observe what traffic you see when the system or node fails to give you some clues as to what is going on ?