Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

implement RFM_ATC in MySensors

Fabien last edited by

Is it possible to implement RFM_ATC (http://lowpowerlab.com/blog/2015/11/11/rfm69_atc-automatic-transmission-control/) in MySensors ?
Reply Quote 0
1 Reply Last reply
hek Admin last edited by

Would be great if you had time to play around with sendWithRetry() and the updated lib to see it works.
Reply Quote 0
1 Reply Last reply
Fabien last edited by

Seems it's too complex for me ... Perhaps someone else. It could be fine for battery powered nodes.
Reply Quote 0
1 Reply Last reply

3
Posts

1325
Views

Log in to reply

Suggested Topics

Controlling Blinds.com RF Dooya Motors with Arduino and Vera
My Project • • petewill

90

7
Votes

90
Posts

73900
Views

Hello everyone, Firstly, I apologize for reviving such an old thread, but I find myself in a unique situation and was hoping some of you might be able to help. I hope everyone's doing well. I have a specific inquiry that I couldn't find a recent solution for. Does anyone here know of a tool to generate "fake" Dooya remote (DC90) RF codes for curtains? I've acquired a few motors without controllers and am trying to integrate them with Home Assistant and Bradlink RF remote. Specifically, I'm searching for a way to generate codes for the Up, Down, Stop, and the "Set" button functions to configure curtain limits. Any insights or guidance would be immensely appreciated. Thank you so much in advance!
debug serial gateway (homeassistant raspberry py 4)
Feature Requests • • Branther

13

0
Votes

13
Posts

67
Views

Just for reference, as this solution was no yet mentioned: You could also use a second UART on your controller or a software serial for debuging with the following defines: #define MY_SERIALDEVICE Serial // Interface for controller connection #define MY_DEBUGDEVICE Serial1 // Interface for debug output Regards, Edi
ESP32 Wired (no WiFi)
Feature Requests • • Marcin

3

0
Votes

3
Posts

16
Views

Nice work there! Thank you for sharing your success, I am sure there will be others who have an interest in this type of set up.
PJON on RS485
Feature Requests • • hypnosiss

3

0
Votes

3
Posts

36
Views

true, but I see in practice pjon is handling collisions more efficient
is there a solution for a relay with button that also works offline?
Feature Requests • • Branther

7

0
Votes

7
Posts

50
Views

super, once again a few super links, thanks for that i will go for the easy way. this sketch by boots33 works perfectly. But before that i will try to understand and learn the steps. thanks again branther
Water leak sensor
Feature Requests • • golferjack

3

0
Votes

3
Posts

492
Views

@kimot thanks this video did help me actually

0
Online

11.4k
Users

11.1k
Topics

112.7k
Posts

Copyright 2019 Sensnology | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1