I have been trying to figure this out all day.
everything works it just reboots over and over all the time.
see the attached picture for a example.
thanks for any help guys
@mvader Turn the time delay adjustment preset on your PIR module to the minimum.. Now try it.. You will not get a continuous output..Also, prepare the circuit using a long wire from the back to the sensor of your module.
https://github.com/mysensors/MySensors/pull/1562 switches to using libgpiod instead of the earlier interface. I have not tested it myself but it looks good.
@jaydenlord Probably you do. If you leave the EN floating, electrical noise could cause it to enable or disable randomly.
Some enable pin require a HIGH, some LOW. Connect it to VCC to see if it works more consistently. If it doesn't detect, connect it to GND.
If one of these works, then the part wasn't designed to be in a default state of enable.
Let us know your results (I found this video
OSD
@tnick STM32F1 2019.12.8 (stm32duino) is the version that was active when the latest MySensors release was made. Later versions may or may not work; nobody would know until they tried.
