I have been trying to figure this out all day.
everything works it just reboots over and over all the time.
see the attached picture for a example.
thanks for any help guys
@mvader Turn the time delay adjustment preset on your PIR module to the minimum.. Now try it.. You will not get a continuous output..Also, prepare the circuit using a long wire from the back to the sensor of your module.
I'm having the same / a simular issue of temperature related readings, but at a different temperature level (for me it must be > 14 degree). I massure the dew point as well (temperature = orange, dew point = yellow). It looks to be more related to water in the air than only to temperature.
@zboblamont have you been finally been able to find a solution?
@Eme
Thank you for coming back to report how you solved your problem! Your comments will help other people.
I am a big fan of Frugal Tech and I think MySensors is great for that.
Alas, MySensors is not well supported anymore. Right now I'm having problems linking to the home page It's people like you and me that will keep MySensors going.
Thanks for your help.
OSD
You write "...clicking is heard..." Is that a single click or a click click click ...?
After getting the LOW signal, wait a period of time and if it's still low, send the message that there is a flame. Likewise for a HIGH signal.
Perhaps instead of a relay, an opto-isolator?
