Dallas Temperature Sensor - compiling error

[Samuel235]

@ciscokid Just to let you know, I'm currently using the 1.5 and the development directory/branch and mine compiles perfectly fine. Try downloading the libraries again and clean install them.

[gmccarthy]

I've been using the Dallas libraries on Arduino 1.6.5 with no issues. Try redownloading Arduino and mysensors api and install into a different directory.

[erpa]

+1 for me too, same compiling error.
Went from IDE 1.6.6 to 1.6.5 as suggested, but have the same error.
Can someone help?
Thanks

[hek]

You're probably using and old/different Dallas library. Sure you use the one provided in the MySensors bundle?

[erpa]

That did the trick, Thanx!!
Copied Dallas directory from "mysensors master" to Arduino library location.
Works with 1.6.6

[Samuel235]

One of the first steps in the troubleshooting process, that i have learnt recently, is exactly this. Making sure the libs are up to date, or even better, not conflicting/co-operating. Hek is the master at pointing out this to us all here ;)

[oded00]

This post is deleted!

[mfalkvidd]

@oded00 Follow the instructions at http://www.mysensors.org/about/arduino#installing-the-sensor-libraries
Make sure you delete everything in the libraries folder before extracting the content of the MySensors library zip archive to delete any old versions.

[markush]

Sorry guys - is this error fixed? Have the same problem after installing fresh dev branch 2.0

The message on compiling is: is private ... within this context

I have declard the section in DallasTemperature.h line 249 in public: and now it works?!?

Pleasy try it - for me it works :+1:

[Samuel235]

@markush - A few comments above is this one:

That did the trick, Thanx!!
Copied Dallas directory from "mysensors master" to Arduino library location.
Works with 1.6.6

That is in reply to Hek's response of:

You're probably using and old/different Dallas library. Sure you use the one provided in the MySensors bundle?

So firstly, I would double check that you have the correct Dallas Lib, the one that is in the MySensors bundle. Also, as mfalkvidd says above your comment, make sure you have extracted the Libs from MySensors correctly.

[markush]

Yes i have read the comments. Make two fresh installs - with the same error on both.

Using Arduino 1.6.7 and the dev branch 2.0

I'm using a network, means my Arduino Sketchbook directory is on a server. Perhaps this is the problem....?

[Peter Mietlowski]

I had the same error and it turned out that for some reason it was finding the library in a folder in My Documents and also in the Arduino install folder. I renamed the copy in My Documents (I don't remember putting it there so maybe it was older version?) and all was well.